main:curvecalibrationwizard
Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
|
Next revision
Both sides next revision
|
main:curvecalibrationwizard [2017/05/19 14:15] bshirley |
main:curvecalibrationwizard [2017/10/25 20:18] yli |
[[main:processedsample | Processed samples]] contained in the Sample list within the [[main:mainGUI | main GUI]] are listed here. If [[main:sample | samples]] are present in the main GUI but the the list in this slide of the wizard is blank, the samples must first be processed. For each sample listed: | [[main:processedsample | Processed samples]] contained in the Sample list within the [[main:mainGUI | main GUI]] are listed here. If [[main:sample | samples]] are present in the main GUI but the the list in this slide of the wizard is blank, the samples must first be processed. For each sample listed: |
* Place a checkmark beside the sample if it should be included in the calibration curve. | * Place a checkmark beside the sample if it should be included in the calibration curve. |
* Update Physical dose from "Unknown" to Grays (Gy) of radiation the sample was exposed to. Note it is only necessary to enter a number in this field, the unit (Gy) should be omitted. | * If Physical Dose has not been auto-filled, update it from "Unknown" to Grays (Gy) of radiation the sample was exposed to . Note it is only necessary to enter a number in this field, the unit (Gy) should be omitted. |
| * If Physical Dose has been auto-filled, check its correctness. |
| |
After these steps have been completed for all required samples, click "next" to move on to the next screen. If a value in the Physical Dose field is invalid, "Physical Dose" will be highlighed in red along with the ID of the sample in the offending line. offending line. | After these steps have been completed for all required samples, click "next" to move on to the next screen. If a value in the Physical Dose field is invalid, "Physical Dose" will be highlighed in red along with the ID of the sample in the offending line. offending line. |
main/curvecalibrationwizard.txt · Last modified: 2017/10/25 20:55 by yli