main:curvecalibrationwizard
Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
|
Last revision
Both sides next revision
|
main:curvecalibrationwizard [2017/10/25 20:18] yli |
main:curvecalibrationwizard [2017/10/25 20:48] yli |
* Place a checkmark beside the sample if it should be included in the calibration curve. | * Place a checkmark beside the sample if it should be included in the calibration curve. |
* If Physical Dose has not been auto-filled, update it from "Unknown" to Grays (Gy) of radiation the sample was exposed to . Note it is only necessary to enter a number in this field, the unit (Gy) should be omitted. | * If Physical Dose has not been auto-filled, update it from "Unknown" to Grays (Gy) of radiation the sample was exposed to . Note it is only necessary to enter a number in this field, the unit (Gy) should be omitted. |
* If Physical Dose has been auto-filled, check its correctness. | * If Physical Dose has been auto-filled, check its correctness. Auto-filled dose may not be correct if its sample ID is not well-formed. |
| |
After these steps have been completed for all required samples, click "next" to move on to the next screen. If a value in the Physical Dose field is invalid, "Physical Dose" will be highlighed in red along with the ID of the sample in the offending line. offending line. | After these steps have been completed for all required samples, click "next" to move on to the next screen. If a value in the Physical Dose field is invalid, "Physical Dose" will be highlighed in red along with the ID of the sample in the offending line. offending line. |
main/curvecalibrationwizard.txt ยท Last modified: 2017/10/25 20:55 by yli