main:curvecalibrationwizard
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
|
|
main:curvecalibrationwizard [2017/10/25 20:48]
yli |
main:curvecalibrationwizard [2017/10/25 20:55]
yli |
| [[main:processedsample | Processed samples]] contained in the Sample list within the [[main:mainGUI | main GUI]] are listed here. If [[main:sample | samples]] are present in the main GUI but the the list in this slide of the wizard is blank, the samples must first be processed. For each sample listed: | [[main:processedsample | Processed samples]] contained in the Sample list within the [[main:mainGUI | main GUI]] are listed here. If [[main:sample | samples]] are present in the main GUI but the the list in this slide of the wizard is blank, the samples must first be processed. For each sample listed: |
| * Place a checkmark beside the sample if it should be included in the calibration curve. | * Place a checkmark beside the sample if it should be included in the calibration curve. |
| * If Physical Dose has not been auto-filled, update it from "Unknown" to Grays (Gy) of radiation the sample was exposed to . Note it is only necessary to enter a number in this field, the unit (Gy) should be omitted. | * If Physical Dose has not been auto-filled, update it from "Unknown" to Grays (Gy) of radiation the sample was exposed to. Note it is only necessary to enter a number in this field, the unit (Gy) should be omitted. |
| * If Physical Dose has been auto-filled, check its correctness. Auto-filled dose may not be correct if its sample ID is not well-formed. | * If Physical Dose has been auto-filled, check its correctness. Auto-filled dose may not be correct if its sample ID is not well-formed. |
| |
main/curvecalibrationwizard.txt ยท Last modified: 2017/10/25 20:55 by yli
